HP XP Racks - Manual (Page 730)

Table 131 Procedures for Recovering from Each Failure Type (continued)
Recovery Procedures Cause of Failure Copy Pair Status after a Failure Failure Type
S-VOL P-VOL Specific General
To perform
operations from a PSOFF for the
primary DKC. Same as the
pair status
during failure PSOFF
(if the status of the
S-VOL after being
PSOFF for the
primary DKC. PSOFF or
cut power
secondary DKC
without waiting for
(after the DKC is
turned on, the turned on is
SUSPCU/
recovery of the
primary DKC,
status will SUSPER/
execute one of the
following:
change to
SUSPOP or
SUSPER). SWAPPING, the
P-VOL status will
be SUSPER).
•
YKSUSPND with
S-VOL(PERMIT)
specified
•
YKSUSPND with
REVERSE
specified
•
YKRECVER
To perform
operations from a Cut power for the
primary storage
system. Same as the
pair status
during a failure Cut power
(the status will be
SUSPER after the
Power cut to the
primary storage
system (with battery
backup).
secondary storage
system without
(if the status of
the S-VOL is power is turned
on).
waiting for a
recovery of the
DUPLEX or
primary storage
PENDING, after
system, execute one
of the following:
the power is
turned on, the
•
YKSUSPND with
S-VOL(PERMIT)
specified
status will
change to
SUSPOP or
SUSPER).
•
YKSUSPND with
REVERSE
specified
•
YKRECVER
To perform
operations from a Cut power for the
primary storage
system. Same as the
pair status
during a failure Cut power
(the status will be
SUSPER after the
Power cut to the
primary storage
system (without
battery a backup). PSOFF or
cut power
secondary storage
system without
(after the power
is turned on, the power is turned
on).
waiting for recovery
of the primary
status will
storage system,
change to
execute one of the
following:
SUSPOP or
SUSPER).
•
YKSUSPND with
S-VOL(PERMIT)
specified
•
YKSUSPND with
REVERSE
specified
•
YKRECVER
730 Troubleshooting