HP XP Racks - Manual (Page 157)

Table 42 How to Prepare the Configuration Files at each site (3DC Cascade (Cnt Ac-S Z x Cnt Ac-J
Z) Configuration) (continued)
How to Prepare Contents File Type
At the Secondary Site At the Primary Site
Not required Define a path set Path set definition
file •
An inter-control unit logical path from the
primary site to the intermediate site
•
An inter-disk controller logical path from
the intermediate site to the remote site
Define a path set Not required •
An inter-control unit logical path from the
intermediate site to the primary site
• An inter-disk controller logical path from
the remote site to the intermediate site
Not required Define a route list A route/command device from the primary
site, to the intermediate site, and then the
remote site Route list definition
file/Command
device definition
file
Define a route list Not required A route/command device from the remote
site, to the intermediate site, and then the
primary site
Transfer from the primary
site Define a copy group A Cnt Ac-S Z copy group Copy group
definition file
Define a copy group A Cnt Ac-J Z copy group
NOTE: If you define the route list, the route list definition file and the command device definition
file will be created at the same time.
Definition procedure (3DC Cascade (Cnt Ac-S Z x Cnt Ac-J Z) configuration)
First, set the items that need to be set by using Remote Web Console from among the items listed
in
Table 39 (page 155) .
This section explains how to set up a 3DC Cascade (Cnt Ac-S Z x Cnt Ac-J Z) configuration from
the ISPF panel.
The following shows the legend for the figure in the operation procedure of this section:
Defining a 3DC Cascade (Cnt Ac-S Z x Cnt Ac-J Z) configuration 157