HP XP Racks - Manual (Page 298)

//SYSABEND DD SYSOUT=*
//OUTPAIR DD DSN=BCM.PCSV,UNIT=3390,VOL=SER=BCMCSV,DISP=(NEW,CATLG),
// SPACE=(CYL,(1,1)),
// DCB=(RECFM=VB,LRECL=256,BLKSIZE=4096,DSORG=PS)
//OUTEXCTG DD DSN=BCM.ECSV,UNIT=3390,VOL=SER=BCMCSV,DISP=(NEW,CATLG),
// SPACE=(CYL,(1,1)),
// DCB=(RECFM=VB,LRECL=256,BLKSIZE=4096,DSORG=PS)
//OUTCTG DD DSN=BCM.CCSV,UNIT=3390,VOL=SER=BCMCSV,DISP=(NEW,CATLG),
SPACE=(CYL,(1,1)),
DCB=(RECFM=VB,LRECL=256,BLKSIZE=4096,DSORG=PS)
//SYSTSIN DD *
YKEXPORT PREFIX(BCM) GROUP(CG.UR)
/*
The amount of memory required to execute the command depends on the number of volumes used
by the copy group. For details about how to set an appropriate value, see the HP XP7 for Business
Continuity Manager Installation Guide.
Updating an existing copy group definition file
You can update an existing copy group definition file by executing the YKEXPORT command and
YKIMPORT
command. “Example of updating an existing copy group definition file” (page 298)
shows an example of updating an existing copy group definition file.
Figure 114 Example of updating an existing copy group definition file
To update an existing copy group definition file:
1.
Prepare a copy group definition file and disk configuration definition file.
If the device configuration is changed and the disk configuration definition file differs from
the actual device configuration, scan the volumes to be used and re-create a disk configuration
definition file. Note that the contents of the disk configuration definition file must be consistent
with the copy group configuration.
2. Execute the YKEXPORT command.
CSV files are generated.
3. Download the CSV files to your PC.
4. Correct the definitions in the CSV files.
298 Importing copy groups