HP XP Racks - Manual (Page 686)

Example
To put the BCM Monitor instance whose identification name is YK to sleep for the following
conditions, enter the command as shown:
•
Point to put BCM Monitor to sleep: ACTION=STOPPOINT(LABEL1)
•
Sleep duration: 10 minutes
MODIFY YK,SLEEP LABEL1,10
WAKEUP command
To wake up BCM Monitor, use the MODIFY WAKEUP command.
Format
If both the name of the cataloged procedure for startup and the identification name were specified
in the START command:
MODIFY
Δ
1
[cataloged-procedure-for-startup-name.]identification-name
,WAKEUP
If only the name of the cataloged procedure for startup was specified in the START command.
MODIFY
Δ
1
cataloged-procedure-for-startup-name
,WAKEUP
Operands
cataloged-procedure-for-startup-name
Used to specify the name of the cataloged procedure for startup that was specified in the START
command when BCM Monitor was started.
identification-name
Used to specify the identification name that was specified in the START command when BCM
Monitor was started.
WAKEUP
Wakes up BCM Monitor. If BCM Monitor is not sleeping, the WAKEUP request is canceled.
Example
To wake up a BCM Monitor instance whose identification name is YK, enter the following command:
MODIFY YK,WAKEUP
Troubleshooting procedures provided by BCM Monitor
This section describes the troubleshooting procedures provided by BCM Monitor.
Logs collected by BCM Monitor
Table 117 (page 687) shows the different log types, the information collected for each log type,
and the output locations for each log type.
686 Automatic operation using BCM Monitor