HP XP Racks - Manual (Page 218)

Table 67 How to Prepare the Configuration Files at Each Site (HyperSwap) (continued)
How to Prepare Contents File Type
At the Secondary Site At the Primary Site
Not required Define a path set Path set definition file •
An inter-control unit logical path from
the primary storage system to the local
storage system
•
An inter-control unit logical path from
the local storage system to the primary
storage system
• An inter-disk controller logical path from
the primary storage system to the remote
storage system
•
An inter-disk controller logical path from
the local storage system to the remote
storage system
Define a path set Not required • An inter-disk controller logical path from
the remote storage system to the primary
storage system
•
An inter-disk controller logical path from
the remote storage system to the local
storage system
Not required Define a route list Route list definition
file/Command device
definition file • A route/command device from the local
storage system to the remote storage
system
• A route/command device from the
primary storage system to the remote
storage system
Define a route list Not required •
A route/command device from the
remote storage system to the primary
storage system
• A route/command device from the
remote storage system to the local
storage system
Transfer from the primary
site Define a copy group A Cnt Ac-S Z copy group with the
HyperSwap attribute Copy group definition
file
Define a copy group A Cnt Ac-J Z copy group
Define a copy group A Cnt Ac-J Z copy group for Delta Resync
NOTE: If you define the route list, the route list definition file and the command device definition
file will be created at the same time.
Definition procedure (HyperSwap)
First, set the items that need to be set by using Remote Web Console from among the items listed
in
Table 65 (page 216) (excluding a delta resync control path).
This section describes the definition procedure for a 2DC configuration with HyperSwap and
Continuous Access Journal Z.
The following figure indicates the legend of the graphic contents used in the figures represented
in the procedures.
218 Configuration definitions