Creating a path set, Defining the inter-dkc logical path set, Creating a path – HP XP Racks User Manual
Page 591
2008/03/19 15:04:44
Supported actions: s(Select), e(Edit devn)
Device Address Domain : DADP.NG
Description . . . : DISCOVERED-NONGEN-STORAGE
Storage System S/N : 12345 Model : USPV uCode : 600243FF IFType : 2121
Software Keys CA( Y ) CAA ( Y ) BC ( Y ) CAJ ( Y )
------------------------------------------------------------------------------
AC CU SSID Dummy Devn Information
00 6800 NOTSET
******************************* Bottom of data ********************************
F1=Help F3=Exit F7=Backward F8=Forward F12=Cancel
12.
Assign a dummy device number.
For details on how to assign a dummy device number, see
“Assigning a dummy device number”
.
When a dummy device number is assigned, the Scan Device Address Extent panel is displayed
(NG scan is completed).
13.
Repeat steps 6 and 10 through 12 to perform a scan with another scope.
14.
Press the F3=Exit key.
The Discover HP Storage Arrays panel appears.
The Description setting values can be changed. You can change the dummy device number
that has already been assigned to the NG scan target storage system, indicated by a percent
sign (%) next to the storage system serial number.
Creating a path set
Defining the inter-DKC logical path set
This section explains how to define the inter-disk controller logical path, using the inter-disk controller
logical path definition example shown in
Creating a path set
591