HP XP Racks - Manual (Page 274)

Definition procedure (4x4x4 Delta Resync configuration)
Basically, a 4x4x4 Delta Resync configuration is defined in the following procedure.
1. Set up the storage system
Set the items that need to be set from among the items listed in Table 84 (page 271) (except
the Delta Resync control path) by using Remote Web Console.
2. Set up a Business Continuity Manager environment
Do the following:
•
Perform a Local Scan on the storage system at each site, and transfer the disk configuration
definition file containing the scan results of each site to all other sites.
•
At each site, define a path set and establish a logical path.
•
At each site, define a route list and register a command device.
3. Create copy groups
At the primary site, define copy groups, create copy pairs, and register the EXCTG to the
storage system.
Register the EXCTG to the storage system when the YKMAKE command is executed. If the copy
pair has already been created, executing the YKMAKE SELECT(COND) command only
registers the EXCTG.
For details on each definition procedure in this section, see the following:
•
Procedure for a Local Scan
For details, see “Performing a local scan to acquire volume information” (page 125) . For details
on how to operate the ISPF panels, see “Local scan procedure” (page 583) .
•
Procedure for defining a path set and for establishing a logical path
For details, see “Establishing a logical path” (page 127) and “Establishing a logical path”
(page 605) . For details on how to operate the ISPF panels, see “Creating a path set” (page 591) ,
“Establishing a logical path” (page 127) , and “Establishing a logical path” (page 605) .
•
Procedure for defining a route list
For details, see (page 132) . For details on how to operate the ISPF panels, see (page 606) .
•
Procedure for registering a command device
For details, see (page 136) . For details on how to operate the ISPF panels, see (page 634) .
•
Procedure for defining a copy group
For details on how to operate the ISPF panels, see (page 650) , (page 651) , and (page 653) .
Setting up the storage system
Set up the following items by using Remote Web Console.
1.
At the remote site, configure an arbitration command device on the subordinate disk controller.
2. At the remote site, set up an arbitration path from the supervisor disk controller to the
subordinate disk controller.
3. At the remote site, map the arbitration command device on the subordinate disk controller to
the supervisor disk controller (setup of the remote command device).
4. Register the journal group (timer type: SYSTEM) in the storage system at each site.
Setting up a Business Continuity Manager environment
Creating a disk configuration definition file
Perform a scan that includes the volumes to be defined in the copy group and the command device.
274 Configuration definitions