HP XP RAID Manager Software - Manual (Page 259)

Table 102 SSB codes that are returned by raidcom delete path command (continued)
raidcom delete path
Description Error code Executing/
Async Error message
SSB2 SSB1
There is no path group. 4500 2E20 Executing CMDRJE
/Async Get Command Status
Paths cannot be deleted because there are no normal paths. 4300 2E23 Executing CMDRJE
/Async Get Command Status
The port attribute is not External (ELUN). 8400 2E30 Executing CMDRJE
The command cannot be accepted. After a while, execute the
same command. 00EE 2EDA Executing CMDRJE
An internal error occurred. FFFF 2EDA Async Get Command Status
Call HP Technical Support.
Table 103 SSB codes that are returned by raidcom add path command
raidcom add path
Description Error code Executing/
Asynchronous Error message
SSB2 SSB1
The path group is not in the enabled range. 4500 2E00 Executing CMDRJE
The value of specified port is incorrect. 8400 2E00 Executing CMDRJE
The WWN on the side of specified external storage is not
connected to an External port. 4400 2E10 Asynchronous Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
There is no external volume group. 4100 2E20 Executing CMDRJE
Invalid WWN. 4400 2E20 Asynchronous Get Command Status
There is no path group. 4500 2E20 Executing CMDRJE
/Asynchronous Get Command Status
The same path has been defined already. 4300 2E22 Executing/Asynchronous CMDRJE
Get Command Status
The operation cannot be done because the number of path in
the path group exceeds 8. 4303 2E23 Asynchronous Get Command Status
The attribute of a port is not External (ELUN). 8400 2E30 Executing CMDRJE
The specified external storage LU is the device of not supported. 4000 2E31 Asynchronous Get Command Status
The specified external storage system is not supported. 4001 2E31 Asynchronous Get Command Status
The command cannot be accepted. After a while, execute the
same command. 00EE 2EDA Executing CMDRJE
An internal error occurred. FFFF 2EDA Asynchronous Get Command Status
Call HP Technical Support.
Error messages and error codes 259