HP XP RAID Manager Software - Manual (Page 216)

Table 57 SSB codes that are returned by raidcom add journal command
raidcom add journal
Description Error code Executing/
Asynchronous Error message
SSB2 SSB1
The value of LDEV number is invalid. 0000 2E00 Executing CMDRJE
A new journal volume cannot be registered because the number
of journal volume exceeds the maximum that can be registered. 0018 2E00 Executing CMDRJE
The specified volume capacity is too small. 0023 2E00 Asynchronous Get Command Status
The journal start threshold value, or the journal end threshold
value is incorrect. 500A 2E00 Asynchronous Get Command Status
The specified CLPR number is incorrect. 7000 2E00 Asynchronous Get Command Status
The specified cache value of a journal on the primary or the
secondary side is incorrect. 8101 2E00 Asynchronous Get Command Status
The total cache amount is incorrect. 8102 2E00 Asynchronous Get Command Status
The specified MP Blade ID is invalid. 8301 2E00 Executing CMDRJE
The specified volume is already used by another program
product. 0000 2E10 Asynchronous Get Command Status
The specified volume is not installed or cannot be used. 0011 2E10 Asynchronous Get Command Status
The specified volume is connected from the mainframe host. 001A 2E10 Asynchronous Get Command Status
There is a PIN slot in the journal volume. 001B 2E10 Asynchronous Get Command Status
The specified volume cannot be registered as a journal volume
because it is in shredding. Wait until the shredding operation
is completed, then retry the operation. 001C 2E10 Asynchronous Get Command Status
The specified operation failed because the journal or mirror is
not in the operable status. 5000 2E10 Asynchronous Get Command Status
The operation cannot be done because it is in the state of
start-up. 800B 2E11 Asynchronous Get Command Status
The operation cannot be done because the internal processing
is in progress. Wait for a while, then retry the operation. 800E 2E11 Asynchronous Get Command Status
Abnormal cache status. 810A 2E11 Asynchronous Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
The specified LDEV is not defined. 0000 2E20 Executing CMDRJE
The specified MP Blade is not installed. 8300 2E20 Executing CMDRJE
The operation failed because the specified journal is not
installed. 5000 2E21 Asynchronous Get Command Status
The journal volume cannot be added, or the journal cannot be
added to the extended CT group due to insufficient capacity of
the shared memory (SM). 8104 2E21 Asynchronous Get Command Status
The SM for Continuous Access Journal is not installed. 8105 2E21 Executing CMDRJE
A journal volume cannot be registered, or a journal cannot be
added to the extended CT group because the program product 9000 2E21 Asynchronous Get Command Status
of Continuous Access Journal or Continuous Access Journal Zis
not installed.
216 Troubleshooting