HP XP RAID Manager Software - Manual (Page 258)

Table 101 SSB codes that are returned by raidcom disconnect path command
raidcom disconnect path
Description Error code Executing/
Asynchronous Error message
SSB2 SSB1
The path group is out of the enabled range. 4500 2E00 Executing CMDRJE
The value of specified port is invalid. 8400 2E00 Executing CMDRJE
The specified external path has already disconnected the path,
or is in the process of checking path. 4301 2E10 Asynchronous Get Command Status
The target LDEV is blocked. 001B 2E11 Asynchronous Get Command Status
The path for the specified external path is in the state of
disconnected. 4000 2E11 Asynchronous Get Command Status
All the specified external paths are blocked. 4302 2E11 Asynchronous Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
There is no specified external volume. 4100 2E20 Executing/Asynchronous Get Command Status
CMDRJE
There is no connection path to an external volume. 4300 2E20 Executing/Asynchronous Get Command Status
CMDRJE
WWN is not registered. 4400 2E20 Executing CMDRJE
There is no path group. 4500 2E20 Executing CMDRJE
external_wwn is not defined. 4500 2E20 Executing CMDRJE
Online from the mainframe host. 001E 2E30 Asynchronous Get Command Status
The attribute of a port is not External(ELUN). 8400 2E30 Executing CMDRJE
The command cannot be accepted. After a while, execute the
same command. 00EE 2EDA Executing CMDRJE
An internal error occurred by the operation of a path for an
external path. 0905 2EDA Asynchronous Get Command Status
Call HP Technical Support.
Table 102 SSB codes that are returned by raidcom delete path command
raidcom delete path
Description Error code Executing/
Async Error message
SSB2 SSB1
The path group is not in a effective range. 4500 2E00 Executing CMDRJE
The value of the specified port is incorrect. 8400 2E00 Executing CMDRJE
The operation cannot continue because the microcode is being
replaced. 8011 2E11 Async Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
There is no external volume group. 4100 2E20 Executing CMDRJE
There is no external connection path. 4300 2E20 Executing CMDRJE
WWN is not registered. 4400 2E20 Executing CMDRJE
258 Troubleshooting