HP XP RAID Manager Software - Manual (Page 241)

Table 78 SSB codes returned by raidcom modify snapshot (continued)
raidcom modify snapshot
Description Error code Executing/Async Error message
SSB2 SSB1
A pair cannot be created because there are not enough free
shared memory space. 8102 2E10 Executing CMDRJE
The command ends abnormally because other than the
raidcom add snapshot command is issued for the volume
other than the Fast Snap or Snapshot pair. 9700 2E10 Executing CMDRJE
The command ends abnormally because the pair is in the
state of unacceptable the command. 9701 2E10 Executing CMDRJE
The Fast Snap or Snapshot pair cannot be restored because
the volume is shared between the P-VOL of a Fast 9702 2E10 Executing CMDRJE
Snap/Snapshot pair and the S-VOL of a Continuous Access
Synchronous pair.
The Fast Snap or Snapshot pair cannot be restored because
the volume is shared between the P-VOL of a Fast 9703 2E10 Executing CMDRJE
Snap/Snapshot pair and the S-VOL of a Continuous Access
Journal pair.
The Fast Snap or Snapshot pair cannot be restored due to
one of the following reasons: 9704 2E10 Executing CMDRJE
• Snapshot data of a restore target Fast Snap or Snapshot
pair is being obtained per consistency group.
•
Snapshot data of a different pair whose primary volume
is the restore target P-VOL of a Fast Snap or Snapshot
pair is being obtained per consistency group.
An error occurred at the operation of Fast Snap due to one
of the following reasons: 9800 2E10 Executing CMDRJE
• The LDEV number specified for the P-VOL or the S-VOL
is incorrect.
•
The LDEV specified as the P-VOL or the S-VOL is not
paired.
• The pair of the specified P-VOL or the S-VOL is not ready
to perform the specified operation.
•
The specified Snapshot ID (MU number) is wrong.
• The specified Snapshot ID (MU number) is already used.
•
The specified pool is not in the usable status.
•
The license capacity has exceeded the maximum.
• The control table for Fast Snap is depleted.
The specified LDEV is not defined. 0000 2E20 Executing CMDRJE
The command ends abnormally because an unmounted
volume is specified as the P-VOL of a Fast Snap or Snapshot
pair. 0008 2E20 Executing CMDRJE
The command ends abnormally because the blocked volume
is specified as the P-VOL of a Fast Snap or Snapshot pair. 0009 2E20 Executing CMDRJE
The command ends abnormally because the volume in
formatting operation is specified as the P-VOL of a Fast Snap
or Snapshot pair. 000A 2E20 Executing CMDRJE
The command ends abnormally because the shared memory
(FC, TPF, or Extension3) is not expanded for necessary
capacity. 8107 2E21 Executing CMDRJE
Error messages and error codes 241