HP XP RAID Manager Software - Manual (Page 194)

Table 40 System log messages (continued)
Recommended action Cause Condition Message ID
Refer to the HORCM startup log to identify
the cause of the error. A system I/O error occurred or
an error exists in the HORCM HORC/HOMRCF and the
RAID Manager software
communication fails. HORCM_101
configuration file
($HORCM_CONF).
Call HP Technical Support. The pair status was suspended
due to code XXXX. The volume is suspended. HORCM_102
Please confirm the following items, and
use raidvchkdsp -v command
for verifying the validation parameters. A validation error occurs on the
database volume, or validation
parameters for this volume are
illegal. Detected a validation check
error on this volume (xxxx
unit#x,ldev#x) : CfEC=n,
MNEC=n, SCEC=n,
BNEC=n HORCM_103
(1) Check if the block size (-vs ) is
an appropriate size.
(2) Check if the type for checking (-vt
) is an appropriate type.
(3) Check if the data validations are
disabled for LVM configuration changes.
(4) Check if the data validations are not
used based on file system.
(5) Check if the redo log and data file are
separated among the volumes.
Command error messages
The following table lists and describes the command error messages and their return values and
provides recommended action for resolving the error conditions.
Table 41 Command error messages
Value Recommended action Condition Error Error code
message
255 Verify that HORCM is running by
using UNIX commands [ps - ef |
grep horcm]. This command failed to
communicate with the RAID
Manager software. Can’t communicate
with HORC
Manager EX_COMERR
254 Please designate the correct option
using the -h option. An option or arguments of
an option are not sufficient. Required Arg list EX_REQARG
253 Please designate the correct option
using the -h option. An option or arguments of
an option are incorrect. Invalid argument EX_INVARG
252 Please designate the correct option
using the -h option. Designated an unknown
option. Unknown option EX_UNWOPT
251 Please verify that HORCM is running
and/or that HORCMINST is set
correctly. Could not connect with
HORCM. Can’t be attached to
HORC Manager EX_ATTHOR
250 Verify that HORCM is running by
using UNIX commands [ps - ef |
grep horcm]. Failed to communicate with
HORCM, or cannot make a
log directory file. Can’t be attached to
a Debug layer EX_ATTDBG
249 Please designate the correct option
using the -h option. The name specified in an
argument of an option is not
appropriate. Invalid name of
option EX_INVNAM
248 Call HP Technical Support. Detected contradiction in
information that RAID
reported. A specified option is
invalid EX_OPTINV
194 Troubleshooting