HP XP RAID Manager Software - Manual (Page 232)

Table 76 SSB codes that are returned by raidcom add snap_pool command
raidcom add snap_pool
Description Error code Executing/
Async Error message
SSB2 SSB1
The value of LDEV number is out of range. 0000 2E00 Async Get Command Status
Pool ID is out of range. 6000 2E00 Executing CMDRJE
The type of pool is invalid. 6001 2E00 Executing CMDRJE
The maximum reserve ratio for V-VOL is out of range. 6002 2E00 Executing CMDRJE
The specified LDEV is in the state of blocked. 0009 2E10 Async Get Command Status
The specified LDEV is in the state of blocked, or not installed. 0011 2E10 Executing CMDRJE
Fast Snap cannot be used because there are not enough cache
management devices to create pairs. 0050 2E10 Async Get Command Status
The pool is not in the status where the pool volume can be
added. 6003 2E11 Executing
/Async
CMDRJE
Get Command Status
The operation cannot be done because the power supply is
switched off. 8003 2E11 Async Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
The specified LDEV is not installed. 0000 2E20 Async Get Command Status
The operation cannot be performed because the memory
capacity of the shared memory (SM) is insufficient. 8103 2E21 Async Get Command Status
The operation cannot be done because the SM for Fast Snap
or Snapshot is not initialized. 8106 2E21 Async Get Command Status
Fast Snap or Snapshot program product is not installed. 9007 2E21 Executing CMDRJE
Exceeded the number of pool volume that can be registered in
a pool. 0005 2E22 Async Get Command Status
The larger number of drive types than the supported
configuration cannot be added to the specified pool. 000D 2E22 Async Get Command Status
Pool volume cannot be registered because the drive type of
specified LDEV is different from the other pool volume type, or
the drive type in the pool exceeds the three. 6100 2E22 Async Get Command Status
The emulation type of specified LDEV cannot be used as a pool
VOL. 0000 2E30 Async Get Command Status
The specified LDEV has the LU path definition. 0007 2E30 Async Get Command Status
The specified LDEV is used as a External Storage Access
Manager quorum disk. 000C 2E30 Async Get Command Status
The specified LDEV is used as a system disk. 000D 2E30 Async Get Command Status
The specified LDEV is already used as a pool volume. 000E 2E30 Async Get Command Status
The specified LDEV is a command device. 0010 2E30 Async Get Command Status
It cannot be used as a pool volume because the size of specified
LDEV is less than 8GB. 0038 2E30 Async Get Command Status
Creating a pool or adding a pool volume cannot be done
because CLPR is mixed in the specified pool. 0039 2E30 Async Get Command Status
The specified LDEV is used as a V-VOL. 005C 2E30 Async Get Command Status
232 Troubleshooting