HP XP RAID Manager Software - Manual (Page 169)

Figure 62 Example for the two-host configuration
Figure 63 Example for the one-host configuration
Target commands for protection
The following commands are controlled by the Data Protection Facility: horctakeover,
paircurchk
, paircreate, pairsplit, pairresync, pairvolchk, pairevtwait,
pairsyncwait , raidvchkset, raidvchkdsp (pairdisplay is not included). When the
command is issued to non-permitted volumes, RAID Manager rejects the request with error code
“EX_ENPERM”.
•
The pairdisplay command shows all volumes, so that you can confirm non-permitted
volumes. Non-permitted volumes are shown without LDEV# information. As shown below, the
LDEV# information is “ **** “ (-CLI is “ – “).
# pairdisplay -g oradb
Group PairVol(L/R) (Port#,TID,LU-M),Seq#, LDEV#.P/S,Status, Seq#,P-LDEV# M
oradb oradev1(L) (CL1-D , 3, 0-0) 35013 ****..- -,- -
oradb oradev1(R) (CL1-D , 3, 1-0) 35013 ****..- -,- -
•
The raidscan command shows all volumes same as current specification, because it does
not need HORCM_DEV and HORCM_INST on horcm.conf. If you want to know permitted
volumes at raidscan, use raidscan -find. The -find option shows device file name
and storage system information by using internal Inquiry result. You can use raidscan
Data Protection facility 169