HP XP RAID Manager Software - Manual (Page 231)

Table 75 SSB codes that are returned by raidcom delete pool command (continued)
raidcom delete pool
Description Error code Executing/
Asynchronous Error message
SSB2 SSB1
All pool volumes associated to a pool cannot be deleted. 600B 2E00 Asynchronous Get Command Status
The specified LDEV is in the state of blocked. 0009 2E10 Asynchronous Get Command Status
This pool cannot be deleted because a volume in the pool is
being deleted. 600D 2E10 Executing CMDRJE
The operation cannot be done because the pool usage rate
exceed the threshold value of the pool usage. 600E 2E10 Asynchronous Get Command Status
The operation cannot be done because the current capacity rate
exceeds the value of maximum reserved capacity rate. 600F 2E10 Asynchronous Get Command Status
It cannot be deleted because the pool volume is set in the state
of being deterred deleting. 6010 2E10 Asynchronous Get Command Status
Deleting operation cannot be done because it is being discarded
pages. 6011 2E10 Asynchronous Get Command Status
The operation cannot be done because a Fast Snap or Snapshot
pair remains or the association with a Thin Provisioning virtual
volume exists. 001F 2E11 Executing/
Asynchronous
CMDRJE
Get Command Status
The operation cannot be done because a Fast Snap or Snapshot
pair is being deleted or a Thin Provisioning virtual volume is
being deleted. 0020 2E11 Asynchronous Get Command Status
The operation cannot be done because a pool volume of a
specified pool is being formatted. 0021 2E11 Asynchronous Get Command Status
The pool is not in the status where the pool can be deleted or
a pool volume can be deleted. 6003 2E11 Asynchronous Get Command Status
The operation cannot be done because the power supply is
switched off. 8003 2E11 Asynchronous Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
The specified LDEV is not registered to the pool. 0003 2E20 Executing CMDRJE
The operation cannot be done because the pool volume is not
of a specified pool. 0003 2E20 Asynchronous Get Command Status
Pool ID is not installed. 6000 2E20 Executing/Asynchronous CMDRJE
Get Command Status
The specified LDEV cannot be deleted because it is a top VOL
of the pool. 0052 2E30 Executing CMDRJE
The specified pool is a pool for Snapshot. 6003 2E30 Executing CMDRJE
The command cannot be accepted. After a while, execute the
same command. 00EE 2EE7 Executing CMDRJE
Pool ID is not installed. 00F9 2EE7 Executing CMDRJE
An internal error occurred. FEEC 2EE7 Executing CMDRJE
Call HP Technical Support.
The specified parameter is invalid. Check the HP P9000 RAID
Manager Reference Guide. 6002 2EF3 Executing CMDRJE
Error messages and error codes 231