HP XP RAID Manager Software - Manual (Page 237)

Table 77 SSB codes returned by raidcom add snapshot (continued)
raidcom add snapshot
Description Error code Executing/Async Error message
SSB2 SSB1
A Fast Snap pair cannot be created because the maximum
number of Snapshot IDs (MU numbers) has already been
in use for the specified P-VOL. 9706 2E10 Executing CMDRJE
A Fast Snap pair cannot be created because the maximum
number of Snapshot groups has already been defined, or 9707 2E10 Executing CMDRJE
the maximum number of Fast Snap pairs has already been
defined in the specified Snapshot group.
A Fast Snap pair cannot be created because the DP pool
is being initialized. 9708 2E10 Executing CMDRJE
An error occurred at the operation of Fast Snap due to one
of the following reasons: 9800 2E10 Executing CMDRJE
•
The LDEV number specified for the P-VOL or the S-VOL
is incorrect.
• The LDEV specified as the P-VOL or the S-VOL is not
paired.
•
The pair of the specified P-VOL or the S-VOL is not ready
to perform the specified operation.
• The specified Snapshot ID (MU number) is wrong.
•
The specified Snapshot ID (MU number) is already used.
• The specified pool is not in the usable status.
•
The license capacity has exceeded the maximum.
•
The control table for Fast Snap is depleted.
A Fast Snap or Snapshot pair cannot be created because
the specified P-VOL is a LUSE volume. 0000 2E13 Executing CMDRJE
A pair cannot be created because there is a pair in the
specified primary volume, which is using a different pool
number from the specified pool number. 6003 2E13 Executing CMDRJE
The specified pair operation cannot be performed for the
specified pool. 6004 2E13 Executing CMDRJE
The consistency group to be used in the specified Snapshot
Group is in one of the following status: 9900 2E13 Executing CMDRJE
•
The number of pairs that can be defined in a consistency
group exceeds the maximum.
•
The pair created by using the same P-VOL already exists
in the specified consistency group.
The specified LDEV is not defined. 0000 2E20 Executing CMDRJE
The command ends abnormally because an unmounted
volume is specified as the P-VOL of a Fast Snap or Snapshot
pair. 0008 2E20 Executing CMDRJE
The command ends abnormally because the blocked
volume is specified as the P-VOL of a Fast Snap or Snapshot
pair. 0009 2E20 Executing CMDRJE
The command ends abnormally because the volume in
formatting operation is specified as the P-VOL of a Fast
Snap or Snapshot pair. 000A 2E20 Executing CMDRJE
Error messages and error codes 237