HP XP RAID Manager Software - Manual (Page 243)

Table 80 SSB codes returned by raidcom delete snapshot (continued)
raidcom delete snapshot
Description Error code Executing/Async Error message
SSB2 SSB1
The command ends abnormally because the Auto LUN
reserved volume is specified as the P-VOL of a Fast Snap
or Snapshot pair. 0036 2E10 Executing CMDRJE
The command ends abnormally because the Business Copy
pair is being resynchronized when the volume is shared 0049 2E10 Executing CMDRJE
between the P-VOL of a Fast Snap/Snapshot pair and the
P-VOL of a Business Copy pair.
The command ends abnormally because the Business Copy
pair status is other than PSUS when the volume is shared 004A 2E10 Executing CMDRJE
between P-VOL of a Fast Snap/Snapshot pair and the
S-VOL of a Business Copy pair.
A Snapshot data cannot be obtained because the
Continuous Access Synchronous asynchronous pair status 004D 2E10 Executing CMDRJE
is other than PSUS or PSUE when the volume is shared
between the P-VOL of a Fast Snap/Snapshot pair and the
S-VOL of a Continuous Access Synchronous asynchronous
pair.
The operation cannot be performed because the Quick
Restore is being operated on the specified Business Copy
P-VOL. 004E 2E10 Executing CMDRJE
A Snapshot data cannot be obtained because the pool or
the pool-VOL is blocked. 6019 2E10 Executing CMDRJE
The command ends abnormally because other than the
raidcom add snapshot command is issued for the volume
other than the Fast Snap or Snapshot pair. 9700 2E10 Executing CMDRJE
The command ends abnormally because the pair is in the
state of unacceptable the command. 9701 2E10 Executing CMDRJE
An error occurred at the operation of Fast Snap due to one
of the following reasons: 9800 2E10 Executing CMDRJE
•
The LDEV number specified for the P-VOL or the S-VOL
is incorrect.
•
The LDEV specified as the P-VOL or the S-VOL is not
paired.
•
The pair of the specified P-VOL or the S-VOL is not ready
to perform the specified operation.
•
The specified Snapshot ID (MU number) is wrong.
•
The specified Snapshot ID (MU number) is already used.
• The specified pool is not in the usable status.
•
The license capacity has exceeded the maximum.
• The control table for Fast Snap is depleted.
The specified LDEV is not defined. 0000 2E20 Executing CMDRJE
The command ends abnormally because an unmounted
volume is specified as the P-VOL of a Fast Snap or Snapshot
pair. 0008 2E20 Executing CMDRJE
The command ends abnormally because the blocked
volume is specified as the P-VOL of a Fast Snap or Snapshot
pair. 0009 2E20 Executing CMDRJE
Error messages and error codes 243