HP XP RAID Manager Software - Manual (Page 245)

Table 82 SSB codes that are returned by raidcom delete ssid command (continued)
raidcom delete ssid
Description Error code Executing/
Asynchronous Error message
SSB2 SSB1
The operation cannot be done because the microcode is being
changed. 8004 2E11 Executing CMDRJE
The serial number, the product ID, or the SSID of the remote
storage system is invalid. 3000 2E20 Executing CMDRJE
The command cannot be executed because the specified RCU
is not registered. 3001 2E20 Executing CMDRJE
The number of the specified SSIDs is invalid. 3301 2E23 Executing CMDRJE
An internal error occurred. 00EF 2ED6 Executing CMDRJE
Call HP Technical Support.
The SSID is invalid. 3300 2ED6 Executing CMDRJE
Table 83 SSB codes that are returned by raidcom add thp_pool command
raidcom add thp_pool
Description Error code Executing/
Async Error message
SSB2 SSB1
LDEV number is out of rage. 0000 2E00 Async Get Command Status
The value of pool ID is out of range. 6000 2E00 Executing CMDRJE
The type of pool is invalid. 6001 2E00 Executing CMDRJE
The maximum reserve ratio of V-VOL is out of range. 6002 2E00 Executing CMDRJE
The threshold of the specified High water mark is out of range. 6009 2E00 Executing CMDRJE
The operation cannot be done because the specified threshold
of Warning is larger than the threshold of the specified High
water mark. 600A 2E00 Executing CMDRJE
The specified LDEV is in the state of blocked. 0009 2E10 Async Get Command Status
The operation cannot be done because a SATA-E drive in the
state of quick formatting is in the specified LDEV. 000C 2E10 Async Get Command Status
The specified LDEV is in the state of blocked, or not installed. 0011 2E10 Executing CMDRJE
The operation cannot be performed because the pool volume
is being deleted. 600D 2E10 Async Get Command Status
The specified operation is not supported in the current microcode
version. 8002 2E10 Async Get Command Status
The pool is not in the status where the pool volume can be
added. 6003 2E11 Executing
/Async
CMDRJE
Get Command Status
The operation cannot be done because the power supply is
switched off. 8003 2E11 Async Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
The specified LDEV is not installed. 0000 2E20 Async Get Command Status
Error messages and error codes 245