HP StorageWorks 6000 Virtual Library System - Manual (Page 292)

CAUTION:
Use only Compaq branded or HP DIMMs. DIMMs from other sources may adversely affect data
integrity.
To replace the component, reverse the removal procedure.
NOTE:
DIMMs do not seat fully if turned the wrong way.
When replacing a DIMM, align the DIMM with the slot and insert the DIMM firmly, pressing down
until the DIMM snaps into place. When fully seated, the DIMM slot latches lock into place.
NOTE:
Be sure all DIMM retention clips are in the closed/locked position before re-installing the processor
memory board into the node.
Processor
CAUTION:
To prevent possible node malfunction and damage to the equipment, replace the processors with the
same make and type of processor.
CAUTION:
If reusing the heatsink, clean and apply thermal grease to prevent thermal failure. The syringe in this
kit contains 1.0 gm (0.5 ml) or 0.5 gm (0.25 ml) of grease designed for use as a thermal interface
between the processor and the heatsink.
1. Remove the processor memory board. See Processor Memory Board .
Component Replacement 292