HP StorageWorks 6000 Virtual Library System - Manual (Page 133)

7 User Interfaces
This section describes the three user interfaces (UIs) that can be used to configure, manage, and
monitor the VLS over the web, remotely over the LAN, or through a serial connection. It also provides
instructions on how to open and close a connection to the VLS for each type of user interface.
User Interface Requirements
VLS user interfaces lists the VLS user interfaces and their requirements. Of the three user interfaces,
Command View VLS should be used in most circumstances. It is the most intuitive and easiest to learn
and use.
Multiple user interface sessions may be open at once.
Table 5 VLS user interface requirements
For more information Configuration Requirements User interface
See “ Command View
VLS ” on page 133.
10/100/1000 BaseT
Ethernet port configured
with an appropriate IP
address, host name,
domain name, subnet
mask, and gateway
Can login as
Administrator or User
PC or workstation network
attached to the VLS run-
ning Microsoft Internet
Explorer 6.0 or higher, or
Netscape Navigator 4.7
or higher
Command View VLS
See “ Secure Shell and
Serial User Inter-
faces
” on page 138.
10/100/1000 BaseT
Ethernet port configured
with an appropriate IP
address, subnet mask,
and gateway
Can login as
Administrator only
Secure shell client (such
as PuTTY) network at-
tached to the VLS
Secure shell (ssh)
See “ Secure Shell and
Serial User Inter-
faces
” on page 138.
Only one serial
connection at a time is
permissible
Can login as
Administrator or
Emergency user
Null-modem cable at-
tached to the VLS and
terminal emulation pro-
gram (such as Windows
Hyperterminal™) con-
figured to 115200 baud
Serial
Command View VLS
Command View VLS is a web browser-based GUI that you can use to configure, manage, and monitor
your VLS through a LAN. Command View VLS provides the following:
HP StorageWorks 6000–series Virtual Library System User Guide 133