HP StorageWorks 6000 Virtual Library System - Manual (Page 267)

3. Pull the CD-ROM drive out of the node.
Figure 80 Ejecting the CD-ROM drive
.
To replace the component:
1. Carefully align the connector on the rear of the drive with the connector on the CD-ROM/diskette
drive interface board.
2. Slide the drive into the bay until it clicks.
Power Supply
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all bays are
populated with either a component or a blank.
1. Disconnect the power cord from the power supply.
2. Press the power supply release lever, and then pull the power supply from the node.
Figure 81 Removing a node power supply
.
To replace the component:
WARNING!
To reduce the risk of electric shock or damage to the equipment, do not connect the power cord to
the power supply until the power supply is installed.
HP StorageWorks 6000–series Virtual Library System User Guide 267