HP StorageWorks 6000 Virtual Library System - Manual (Page 287)

2. Use the Torx T-15 tool to press the ejection button for the DVD-CD drive, and pull the DVD-CD
drive out of the drive bay. See
Locating and Removing the Torx T-15 Tool (VLS6800 node only) .
Figure 100 Removing the DVD-CD drive
.
To replace the component:
1. Insert the DVD-CD drive into the drive bay until it seats.
2. Power on the node. See Powering on the VLS6000–series System .
Power Supply
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all bays are
populated with either a component or a blank.
1. If present, remove the Torx T-15 shipping screw from the bottom of the node with the Torx T-15
tool. See
Locating and Removing the Torx T-15 Tool (VLS6800 node only) .
2. Press the release button on the locking lever upward.
3. Pull down on the locking lever.
HP StorageWorks 6000–series Virtual Library System User Guide 287