HP StorageWorks 6000 Virtual Library System - Manual (Page 268)

1. Remove the protective cover from the connector pins on the power supply.
2. Slide the power supply into the bay until it clicks.
Figure 82 Installing an AC power supply
. 3. Use the strain relief clip to secure the power cord ( Figure 83 ).
Figure 83 Placing the power cord in the strain relief clip
. 4. Connect the power cord to the power supply.
5. Be sure that the power supply LED is green.
Power Supply Zone Fan Module
CAUTION:
Do not operate the node for long periods without the access panel. Operating the node without the
access panel results in improper airflow and improper cooling that can lead to thermal damage.
1. Power off the node.
2. Extend or remove the node from the rack.
3. Remove the access panel.
4. Remove the SATA cable from the cable clip to avoid damaging the cable.
Component Replacement 268