HP StorageWorks 6000 Virtual Library System - Manual (Page 290)

4. Remove the processor memory board.
Figure 103 Removing a processor memory board
.
To replace the component:
1. Install the processor memory board.
2. Re-install the node access panel. See Installing the VLS6800 Node Access Panel .
3. Press the rail-release levers at the front of both node rails and slide the node into the rack.
4. Secure the node in the rack by tightening the thumbscrews.
5. Power on the node. See Powering on the VLS6000–series System .
Processor Power Module
1. Remove the processor memory board. See Processor Memory Board .
Component Replacement 290