HP StorageWorks 6000 Virtual Library System - Manual (Page 280)

1. Power off the node.
NOTE:
The ejector button for the CD-ROM drive is recessed to prevent accidental ejection; it may
be helpful to use a small, flat, blunt object, such as a key or pen, to push the ejector button.
2. Press the ejector button in firmly until the DVD-CD drive ejects (1).
Figure 92 Removing the DVD-CD drive
. 3. Pull the DVD-CD drive out of the node.
To replace the component:
1. Carefully align the connector on the rear of the drive with the connector on the DVD-CD drive
interface board.
2. Slide the drive into the bay until it clicks.
Figure 93 Installing the DVD-CD drive
.
Component Replacement 280