HP XP Performance Advisor Software - Manual (Page 204)

Table 16 Continuous access configuration data (continued)
Description Screen element
•
Reverse Copy
•
Pair SideFile 30% over
•
Pair SideFile over Suspend
•
SVOL Swap ready Suspend
• Unknown
Type of volume (PVOL or SVOL) configured on the primary
data center. Volume Type
Thick or Thin, indicates virtual volume or physical LDEV. Provision Type
Failed or Active.
NOTE: When Continuous access is configured as Sync
or Async and the selected volume type is SVOL, then you
might encounter the CA Link status as NA - Not Applicable.
CA Link Status
Alarm configuration for the CA pair status. HP XP7
Performance Advisor retrieves the CA pair status during Pair Status Alarm
each performance cycle. If there is a change in the pair
status from the previous performance cycle, an email
notification is sent to the email address specified on the
Email Settings screen. These notifications are not sent if
there is an intermediate change in the pair status during a
performance cycle.
Number of active continuous access paths from a PVOL to
SVOL. No. of Paths
NOTE: When Continuous Access is configured as Sync
or Async and the selected volume type is SVOL, then you
might encounter the status of the number of paths as NA -
Not Applicable.
Fence level of target device (Pair volume). Displays one of
the following: Fence Level
•
ASYNC for asynchronous communications
• DATA, STATE, or NEVER for synchronous
communications
•
JNL for continuous access journal based transactions
Journal ID of the journal group associated with the P-VOL
or S-VOL. The column value includes the journal ID and JNL-ID
mirror ID on which the CA-J pair is created. Example: jnl
ID:mirror ID
CTG ID, which guarantees consistency in the sequence of
asynchronous data transfers for a remote copy volume
group. CTG-ID
Host port assigned for the P-VOL. P-VOL Host Port
Host port assigned for the S-VOL. S-VOL Host Port
CLPR based on the associated volume type (P-VOL or
S-VOL) manages cache for the continuous access
transactions. CLPR
MP blade based on the associated volume type (P-VOL or
S-VOL) processes requests for the continuous access
transactions. MP Blade
204 Viewing XP and XP7 disk array components