HP Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 295)

Appendix B: Auto-deployment process 295
Status Comment Resolution
Configuration
File Too Big The VC configuration file on the TFTP server is too
big. Configuration files are currently limited to 512K
in size.
Remove commands or comments from
the file to make sure that it is smaller than
512K, and start the deployment process
again.
Failed to Clear
Domain
Configuration
A failure occurred while attempting to clear the
domain configuration. This failure is generally
caused by an internal failure, and typically should
not occur.
If this error occurs, it is typically an
internal error that needs to be reported
back to HP Support along with a support
dump for diagnosing the cause.
Failed to
Configure
Domain
The domain configuration script encountered an
error.
If an error occurs with the processing of the
configuration script, typically it is assumed that there
is a problem with the syntax of the script, or a logic
issue in the script. An error in the script causes the
deployment process to enter a wait and retry cycle
where the script on the TFTP server is downloaded
every 10 minutes. If the script has been modified,
then a new deployment process is attempted. If the
script has not changed since the previous
deployment attempt, no operation is performed, and
a new 10 minute wait and retry cycle occurs.
Examine the deployment log and output
to determine the exact cause of failure
(syntax error, logic issue in
script/domain, hardware issue). Correct
the script or configuration.
The deployment log
The deployment log can be displayed with the show auto-deployment log command. The log shows
the timestamps and messages that indicate the main operations during the deployment process. If an error
occurs during the deployment, an appropriate message is indicated in the log for the condition.
Example
->show auto-deployment log
2012-07-26 16:04:34.460 Deployment process started
2012-07-26 16:04:34.462 Validating domain checkpoint
2012-07-26 16:04:38.546 Downloading domain configuration script from TFTP
server (192.168.1.102,myconfig.script)
2012-07-26 16:04:39.239 Domain configuration file successfully downloaded
from TFTP server
2012-07-26 16:04:39.240 Configuring the domain
2012-07-26 16:04:44.925 Deployment completed successfully
The deployment configuration file
The deployment configuration file is the VCMCLI script that is used by the deployment process. The show
auto-deployment config command can be used to view the configuration script used in the last
deployment that occurred.
Example
->show auto-deployment config
add network Network1
add network Network2
add uplinkset UplinkSet1
add uplinkset UplinkSet2