HP Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 204)

Virtual Connect server profiles 204
• Modify FC HBA connection settings, if there are one or more VC Fibre Channel modules in the Virtual
Connect domain
• Assign, unassign, or re-assign the profile to a device bay
• Copy the profile
• Delete the profile
• Modify FCoE HBA connections
• Set FC boot parameters
NOTE: The process to assign, modify, or unassign a profile to an Integrity BL8x0c i2 server blade
can take up to several minutes.
If VC-assigned MAC addresses, WWNs, or non-default Fibre Channel boot parameters are being used, the
server blade must be powered off before any server side changes can be made. FC, FCoE, or iSCSI boot
parameters require the server to be powered off. If the affected server ports all support DCC, and DCC is
operating properly, then the server does not need to be powered off to change the network or allocated
speed. To power off a server blade, see "Server Bay Status screen (on page 265 )" and "Server blade power
on and power off guidelines (on page 281 )."
Changes to Ethernet network and Fibre Channel fabric settings can be made without powering down the
server. For complete information on server power requirements when assigning or removing server profiles,
see "Server profile troubleshooting (on page 280 )."
The screen can be edited only by users with server role permissions, but it is viewable by all authorized users.