HP Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 237)

Virtual Connect modules 237
The following table describes the columns within the Uplink Port Information (Enet) table.
Column Description
Label Uplink port number
Network(s) Network name or the name of the shared uplink associated with this port
Status Shows the link status, link speed, and connectivity of the port. If the port is
unlinked and no connectivity exists, the cause is displayed. For more
information about possible causes, see "Port status conditions (on page 269 )."
Connector Type Displays the physical type of the faceplate connector, type of pluggable
module if one is present, or "Internal" to indicate the inter-switch link is active
on the VC-Enet module.
LAG ID Identifies the group of ports that have been aggregated together to form an
802.3ad Link Aggregation Group. This ID is unique only within a single
VC-Enet module, meaning the same LAG ID can be used on different VC-Enet
modules, but it is only meaningful for ports within the same VC-Enet module.
Connected To Displays the switch LLDP system name or management IP address of the device
that this port is connected to on the other end. The remote device must support
LLDP to display this information.
Detailed Stats / Info (" Ethernet
Port Detailed Statistics screen "
on page 244 )
Click to display detailed statistics about this Ethernet port.
The following table describes the columns within the Uplink Port Information (FC) table.
Column Description
Port Uplink port number
WWN Factory assigned WWPN for this uplink port
SAN Fabric Name of the SAN Fabric connected to this port
Port Speed Setting Speed setting of the uplink port
Connector Status
Status of the uplink port
Connected To WWN of the principal FC switch to which the VC-FC uplink port is connected
Detailed Stats / Info (" FC Port
Detailed Statistics screen " on
page 252 )
Click to display detailed statistics about this FC port.