HP Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 251)

Virtual Connect modules 251
Port Statistic Description
IfHCOutMulticastPkts The total number of packets that higher-level protocols requested be
transmitted, and which were addressed to a multicast address at this
sublayer, including those that were discarded or not sent. For a MAC
layer protocol, this includes both Group and Functional addresses. This
object is a 64-bit version of ifOutMulticastPkts.
IfHCOutBroadcastPckts The total number of packets that higher-level protocols requested be
transmitted, and which were addressed to a broadcast address at this
sublayer, including those that were discarded or not sent. This object is a
64-bit version of ifOutBroadcastPkts.
cosq_ucast_DroppedPkts The accumulated dropped packet count of unicast packet of the queue for
the specified port. For VC FlexFabric 10Gb/24-port module and VC
Flex-10 Enet module, the counter includes unicast and multicast data.
cosq_ucast_OutBytes
The accumulated transmitted byte count of unicast packets of the queue for
the specified port. For VC FlexFabric 10Gb/24-port module and VC
Flex-10 Enet module, the counter is not supported and the value is 0.
cosq_ucast_OutPkts The accumulated transmitted packet count of unicast packets of the queue
for the specified port. For VC FlexFabric 10Gb/24-port module and VC
Flex-10 Enet module, the counter includes both unicast and multicast data.
*These statistics appear for physical uplink ports, physical downlink ports, and Flex-10 subports. All other statistics only
appear for physical uplink and downlink ports.
Remote Device Information* Description
remote_type Type of remote device. Virtual Connect uses this information to configure
the link as an uplink, a stacking link, or to disable. This information is
based on the LLDP data sent by the device to which the port is attached.
remote_discovered_time Time the remote device was identified, represented in seconds. This
information is based on the LLDP data sent by the device to which the port
is attached.
remote_chassis_id_type Chassis ID subtype of the remote device
remote_chassis_id Chassis ID value of the remote device
remote_port_id_type Port ID subtype of the remote device
remote_port_id Port ID value of the remote device
remote_port_desc Port description of the remote device
remote_system_name System name of the remote device. If the remote device is a VC-Enet
module, remote_system_name is the remote device's VC domain name.
remote_system_desc Description of the remote system. If the remote device is a VC-Enet module,
remote_system_desc is the module's hardware description and firmware
revision.
remote_system_capabilities System capabilities of the remote system, for example, repeater, bridge,
or router
remote_mgmt_addr_type Management address subtype of the remote device, for example, IPv4,
IPv6, or DNS
remote_mgmt_addr
Management address of the remote device
*This information is only available for physical uplink and downlink ports. It is not available for Flex-10 subports.
Pluggable Module Information* Description
identifier Identifies the type of serial transceiver. The binary values are defined in
SFF-8472 in the Identifier [Address A0h, Byte 0] field. This field displays
an ASCII representation of those binary values.