HP Integrity NonStop H-Series - Manual (Page 185)

Changing the Paper Size
Designing the Page Layout
8–4 058060 Tandem Computers Incorporated
Changing the
Paper Size
Default: Paper length 11 inches
Paper width 8.5 inches
TFORM refers to the size of the paper it is printing on as the page form.
When you’re using standard paper, the form length is 11 inches; the form
width is 8.5 inches. When you use paper other than this standard size, you
must modify the form size using the STYLE FORM command. This
command includes the dimension you’re changing, a value, and a unit of
measurement. You can use any of the units listed in Table 7-1. If you don’t
enter any unit of measurement, TFORM assumes you mean inches. For
example, to print on paper that is seven inches wide and nine inches long,
you enter:
\ STYLE FORM WIDTH 7 INCHES
\ STYLE FORM LENGTH 9
Measurement unit (if none entered,
TFORM assumes inches)
Command
Dimension
Value
Remember, you can use abbreviations for commands, and you can enter
multiple commands on a single line. Separate multiple commands with a
semicolon:
\ STY FOR WID 7; STY FOR LEN 9
Note For detailed information on using TFORM commands, see “Entering TFORM Commands” in
Section 7.
Entering STYLE FORM LENGTH or STYLE FORM WIDTH without any
value resets the paper size to its default settings.