HP Integrity NonStop H-Series - Manual (Page 142)

Using the SETPROFILE Command to Set Tab Stops
Creating an Oversized Table
5–30 058060 Tandem Computers Incorporated
4. Continue to work your way down the list until you have copied
“BUDGET,” “ACTUAL,” and the horizontal rule into position for each
department. The file should look like the next example (only part of the
file is shown). When you get to the bottom of the screen, you can either
press
NEXT PAGE to scroll the text up, or you can press the ROLL UP key
to scroll the text up one line at a time. Or, you can press
SHIFT and ROLL UP to scroll the screen up eight lines at a time.
Note You can adjust the number of lines SHIFT ROLL UP and SHIFT ROLL DOWN scroll the
text by changing the repeat count number on the RECONFIGURE FUNCTION-KEYS
screen.
Administration
(Yuen)
BUDGET
ACTUAL
-----------------------------------------------------------------------------
Design and layout
(Medici)
BUDGET
ACTUAL
-----------------------------------------------------------------------------
Editing
(McAdams)
BUDGET
ACTUAL
-----------------------------------------------------------------------------
inance
(Riveira)
F
Vertical Rules. It is easy to use the REPLACE command to insert vertical
rules into the table you have set up. You can use the REPLACE response
lines to type the command. Because you will probably use vertical rules
regularly when you create tables, however, you may want to assign the
command to a function key in your TABLE profile so you always have it
available. Both methods are shown here.