NORD Drivesystems BU0505 - Manual (Page 120)

SK 54xE – Users Manual for Frequency Inverters
120 BU 0505 GB-1013
P506
Automatic error
acknowledgement
(Automatic error acknowledgement)
S
0 ... 7
{ 0 }
In addition to the manual error acknowledgement, an automatic one can also be selected.
0 = No automatic error acknowledgement.
1 ... 5 = Numberof permissible automatic error acknowledgements within one mains-on
cycle. After mains off and switch on again, the full amount is again available.
6 = Always: an error message will always be acknowledged automatically if the cause
of the error is no longer present.
7 = Via Deactivate enable: acknowledgement is only possible using the OK / ENTER
key or by mains switch-off. No acknowledgement is implemented by removing the
enable!
NOTE: If (P428) is parameterised to "ON", parameter (P506) "Automatic error acknowledgement"
must not be parameterised to setting 6 "Always" as otherwise the device or system is endangered
due to the possibility of continuous restarting in the case of an active error (e.g. short-circuit to
earth / short circuit).
Pos : 266 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P500-P599/ Paramet er P507 – PPO-T yp @ 0\ mod_1328091974415_388.doc x @ 11042 @ @ 1
P507
PPO-Type
(PPO-Type)
1 ... 4
{ 1 }
This parameter can only be used with the technology unit Profibus, DeviceNet or InterBus.
See also the relevant section of the corresponding supplementary BUS manual.
Pos : 267 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P500-P599/ Paramet er P508 – Profibus-Adresse @ 0\ mod_1328092017167_388. doc x @ 11065 @ @ 1
P508
Profibus address
(Profibus address)
1 ... 126
{ 1 }
Profibus address, only with the technology unit Profibus
See also the additional description for the Profibus control BU 0020
Pos : 268 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P500-P599/ Paramet er P509 – Q uell e Steuerwort @ 0\ mod_1328092104264_388. doc x @ 11088 @ @ 1