West Control Solutions Pro-EC44 - Manual (Page 52)

Pro-EC44 2-Loop Graphical Profile Controller & Recorder
Pro-EC44 Product Manual - 59540-1 October 2013 Page 45
Configuration Menu
This menu can be used as an alternative to the more limited Setup Wizard when the
instrument is configured for the first time in more complex applications, or when further
changes are required to the instruments settings. The configuration menu contains a number
of sub-menus that allow access to all of the available parameters. The correct settings must
be made before attempting to use the instrument in an application. Screens marked w are
also shown in the Setup Wizard.
Entry into the Configuration Menu
CAUTION: Adjustments to these parameters should only be performed by
personnel competent and authorised to do so.
Configuration is entered from the Main Menu
Hold down
R
and press
U
to enter the Main Menu.
Press
D
or
U
to select Configuration Menu
Press
R
to enter the Configuration Menu.
Navigating the Configuration Menu
Configuration contains sub-menus to set-up the Inputs; Control; Outputs; Alarms;
Communications; Recorder; Clock; Display and Lock Codes.
There is also an option to reset the instrument to its factory default settings.
The Input and Control sub-menus contain further sub-menus with configuration and
calibration settings for each process input; control loops 1 & 2 and the digital inputs. Only
parameters that are applicable to the hardware and options fitted will be displayed.
From the Configuration Menu, press
D
or
U
to select the required sub-menu.
Press
R
to enter the sub-menu.
If required, press
D
or
U
to select the next level sub-menu, then press
R
to enter.
Hold down
R
and press
U
to return to next higher menu level.
Scrolling “Help Text” is shown at the bottom of the screens to aid navigation.
Note: Entry into this mode is security-protected by the Configuration Menu
Lock Code. Refer to the Unlock Code section for more details.