West Control Solutions Pro-EC44 - Manual (Page 19)

Pro-EC44 2-Loop Graphical Profile Controller & Recorder
Pro-EC44 Product Manual - 59540-1 October 2013 Page 12
Pre-wiring
– Cautions, Warnings & Information
CAUTION: Installation should be only performed by technically competent
personnel. It is the responsibility of the installing engineer to ensure that
the configuration is safe. Local Regulations regarding electrical installation
& safety must be observed (e.g. US National Electrical Code (NEC) or
Canadian Electrical Code).
CAUTION: This equipment is designed for installation in an enclosure that
provides adequate protection against electric shock. The isolation switch
should be located in close proximity to the unit, in easy reach of the
operator and appropriately marked.
WARNING: This symbol means the equipment is protected throughout by
double insulation. All external circuits connected must provide double
insulation. Failure to comply with the installation instructions may impact
the protection provided by the unit.
WARNING:
TO AVOID ELECTRICAL SHOCK, AC POWER WIRING MUST NOT BE CONNECTED TO THE
SOURCE DISTRIBUTION PANEL UNTIL ALL WIRING PROCEDURES ARE COMPLETED.
CHECK THE INFORMATION LABEL ON THE CASE TO DETERMINE THE CORRECT
VOLTAGE BEFORE CONNECTING TO A LIVE SUPPLY.