beautypg.com

Cleaning spo, Sensors, Cleaning cables and accessories – ZOLL X Series Monitor Defibrillator Rev H User Manual

Page 283: Loading recorder paper

background image

Cleaning instructions

9650-001355-01 Rev. H

X Series Operator’s Guide

24-9

Cleaning SpO

2

Sensors

Clean the SpO

2

sensors with a cloth that has been slightly dampened with one of the

recommended agents listed above. DO NOT submerge the probe or its connector in any liquids
or cleaning agents. Thoroughly wipe off any excess cleaning solution with a dry cloth. Allow
the sensor to completely dry before patient use.

Cleaning Cables and Accessories

Cables, cuff tubing, paddles and other accessories can be wiped clean with a damp cloth
moistened in a mild detergent solution.

Loading Recorder Paper

The unit displays the message PRINTER OUT OF PAPER when the printer is activated without
recorder paper or if the supply runs out during printing.

Use ZOLL recorder paper (part number 8000-000901).

To load the recorder paper into the printer:

1. Insert your fingers into the indentations on the sides of the printer door, pull the door open,

then remove any paper from the spool.

Figure 24-1.

Opening the Printer Door and Removing Paper