ZOLL X Series Monitor Defibrillator Rev H - Manual (Page 109)

The NIBP Numeric Display
9650-001355-01 Rev. H X Series Operator’s Guide 8-3
3. The NIBP option automatically adjusts the blood pressure measurement procedure in
response to certain error conditions such as:
The NIBP Numeric Display
When NIBP monitoring has been set up and the X Series unit has begun taking NIBP
measurements, the systolic, diastolic, and mean blood pressure measurements appear on the
NIBP numeric display as follows:
The following sections describe how to set up NIBP monitoring.
NIBP Setup and Use
To take safe and accurate NIBP measurements using the X Series unit, you must perform the
following steps, each of which corresponds to a section in this chapter. Read each section
carefully before you perform NIBP measurements.
1. Select the correct size cuff.
2. Apply the cuff to the patient.
3. Connect the inflation hose to the X Series unit and to the cuff.
4. Configure NIBP alarms and settings (if the current NIBP alarms and settings are not
appropriate).
5. Press the NIBP button on the X Series unit’s front panel and take the blood pressure
measurement.
Condition Adjustment/Response
The unit cannot detect systolic
pressure The unit automatically increases the cuff inflation
pressure and completes the blood pressure mea-
surement
The unit cannot detect systolic,
diastolic or mean pressure after
180 seconds The unit aborts the blood pressure measurement and
deflates the cuff
The unit detects a fault The unit displays a corresponding error message on
the monitor and aborts the measurement
138
89
(112)
NIBP mmHg