ZOLL X Series Monitor Defibrillator Rev H - Manual (Page 245)

9650-001355-01 Rev. H X Series Operator’s Guide 22–1
Chapter 22
Wireless Communications
The X Series unit can send data through a wireless connection to remote locations. It can send
12-lead report snapshots (including trend data) to a recipient via a ZOLL server. Full disclosure
cases, which also contain trend data, can be automatically retrieved from the X Series unit
using ZOLL RescueNet or ePCR software.
If installed, the unit is equipped to communicate through a WiFi access point,
Bluetooth-equipped device, Ethernet cable, or USB cellular modem.
You can set up a Bluetooth pairing or temporary wireless access point on the X Series unit by
selecting the wireless icon on the display screen. Supervisors can set up permanent WiFi,
Bluetooth, Ethernet, or Cellular profiles (up to 255) in the Setup/Communications menu, which
requires a password.
Once you have set up a wireless connection, you can send 12-lead reports to an email or fax
recipient. Data can also be retrieved automatically using ZOLL RescueNet or ePCR software.
This chapter describes how to set up and use wireless communications capabilities in the
X Series unit.
This chapter contains the following sections:
• The Wireless Icon
• The Wireless Menu
• Setting up Communications in the Supervisor Menu
• Sending a 12-lead report
• Communications System Messages
Important: Test all wireless connections after initial setup and prior to use.