Clear-Com HLI-FBS - Manual (Page 88)

To talk to the all the devices (beltpacks and Main Station) connected to the channel:
1. Connect a headset [ ], using the 4-pin XLR–M connector on the base / rear of the beltpack.
Note:
For the location of the headset connector and the headset key, see
E
in
Table 22: Key to HBP-2X Beltpack connectors and controls ( base view).
2. Press the Talk key [ ].
3. Speak into the headset mic.
To adjust the volume of incoming audio for a channel, turn the appropriate side-mounted
rotary control [ ].
Turn the rotary control [ ] clockwise to increase the volume, and anti-clockwise to decrease volume.
The current volume level for the channel is shown onscreen [ ].
8.2 Entering and exiting Menu mode
Use Menu mode to:
• Configure the settings for the Main Station, including channel and audio settings.
• Monitor beltpack performance and diagnose issues.
To enter Menu mode, press the Menu key [ ]. To exit Menu mode, press the Menu key again.
For more information about using Menu mode on the beltpack, see
6 Configuring and Managing
the HBP-2X Beltpack.
8.3 Adjusting the Program Feed volume level.
To adjust the listen level (volume) of the Program Feed to the beltpack, turn the rear / base rotary control
[ ].
Turn upwards to increase the listen level (volume), and downwards to decrease the listen level (volume).
While the listen level is adjusted, the listen level for the Program Feed [ ] replaces the
standard channel information onscreen.
Note:
The Main Station is used to assign the Program Feed to channels. For more information, see
5.4.2 Assigning the Program Listen to a channel.
86 HelixNet Partyline User Guide