Clear-Com HLI-FBS - Manual (Page 36)

Connecting the HBP-2X Beltpack to the HMS-4X Main Station
To connect the HBP-2X Beltpack to the HMS-4X Main Station:
1. There are two lines (partylines) on the main station, each of which can support up to 10 digital
HBP-2X beltpacks. There are two connectors (3-pin XLR, male and female) for each line.
Connect the cable to the selected connector [ ] on the main station.
Note:
For the location of Lines 1 and 2 (the powerlines) on the main station, see
F G
in
Table 12: Key to HMS-4X Main Station rear panel diagram.
2. Connect the cable to the beltpack, using one of the two 3-pin XLR connectors (male and female)
on the base / rear of the beltpack.
Tip: For example topologies, see 3.1.2 Topologies (layouts).
34 HelixNet Partyline User Guide