Clear-Com HLI-FBS - Manual (Page 59)

5.6.1 Configuring a Four-wire interface module
The following procedure shows you how to configure the Module Settings for a
Four-wire interface module.
To configure the Module Settings for a four-wire interface module:
1. In Menu mode [ ], select Module Settings.
2. From the second menu (second display screen), select one of the two available ports on the two-
wire interface module:
Slot 2/Port A 4W
Slot 2/Port B 4W
Notes:
In this example, the four-wire module has been fitted to slot 2 in the expansion bay. The
expansion bay contains three slots (room for three interface modules).
4W = four-wire.
3. To associate one of the four available channels (or to disable channels associations) with the
selected port:
a. From the third menu (third display screen), select Channel Assign.
b. From the fourth menu (fourth display screen), select one of the following:
• Disabled.
• Channel A.
• Channel B.
• Channel C.
• Channel D.
Note:
The default is Disabled.
Note:
When linking is enabled, there will be more than four channels.
c. To enable (confirm) the selected setting, press the rotary control [ ].
4. To set the Program Output:
a. From the third menu (third display screen), select Program Output.
b. From the fourth menu (fourth display screen), select one of the following:
• Unmute
• Mute
Note:
The default is Unmute.
To enable (confirm) the selected setting, press the rotary control [ ].
57 HelixNet Partyline User Guide