5 four-wire connection to the dx210, Four-wire connection to the dx210 – Clear-Com HLI-FBS User Manual
Page 110
9.5.5 Four-wire connection to the DX210
To connect your HelixNet Partyline system with a DX210 basestation (BS210), using a four-wire
connection:
1. On the HMS-4X Main Station, configure the Module Settings for the Four-wire interface module.
For the procedure, see
5.6.1 Configuring a Four-wire interface module.
2. Connect the HMS-4X Main Station and the DX210 basestation (BS210), using four-wire
crossover CAT5 cabling.
Important note:
For pinout information for the two systems, see the quick reference diagram in
9.5.4 Quick reference: Four-wire connection to DX210.
RJ45 connectors are located:
• On the HMS-4X Main Station Four-wire interface module.
• On the back panel (rear) of the DX210 basestation (BS210).
There is an RJ45 (four-wire) connector for each of the intercom channels on the DX210
base station (IC1 and IC2) . Connect the systems with standard CAT5 cable.
3. Adjust the In / Out volume levels, using the CellCom / FreeSpeak front panel display.
For more information, see your CellCom / FreeSpeak documentation.
Tip:
To optimize audio quality, you may also want to adjust the Audio Settings on the
HMS-4X Main Station. For more information, see 5.2 Configuring the Audio settings
108
HelixNet Partyline User Guide