Clear-Com HLI-FBS - Manual (Page 87)

8 Using the HBP-2X Beltpack
This chapter describes how to use the HBP-2X Beltpack, after your HelixNet Partyline system has been
installed and configured.
For more information about integrating and using HelixNet Partyline with your existing intercom
infrastructure, see 9 Connecting to Other Intercom Systems.
Tip: For a quick reference to the functionality of the HBP-2X Beltpack, the HMS-4X Main Station, and
the optional interface modules, see 2 User Interfaces.
8.1 Using the beltpack keysets
The HBP-2X Beltpack supports two Partyline channels, with a separate keyset (set of controls) dedicated
to the control of each channel:
• The left-hand keyset controls the first (top) channel displayed onscreen.
• The right-hand keyset controls the second (bottom) channel displayed onscreen.
When the beltpack is in operating mode, the following standard information is displayed onscreen for
each channel:
• The channel label [ ].
• The channel volume level [ ].
Notes:
For more information about:
• Using the beltpack in Menu mode, see 6 Configuring and Managin the HBP-2X Beltpack.
• Changing (editing) the channel label (name), see 5.4.1 Editing the channel label.
The display screens enters screensaver mode (if enabled) if the beltpack remains inactive for a [period of
time]. Press any key to exit screensaver mode.
To send a call signal to all the connected devices (beltpacks and Main Station) on that channel, press
the Call key [ ].
85 HelixNet Partyline User Guide