Clear-Com HLI-FBS - Manual (Page 65)

12. The VOX Delay OFF setting determines the length of time to wait before deactivating the
incoming audio. To set the VOX Delay OFF setting:
a. From the third menu (third display screen), select VOX Delay OFF.
b. From the fourth menu (fourth display screen), select one of the following:
• [0].5 sec.
• 1 sec.
• 2 sec.
• 3 sec.
• 4 sec
Note:
The default is [0].5 sec.
c. To enable (confirm) the selected setting, press the rotary control [ ].
5.6.3 Configuring an Ethernet or Fiber interface module
The following procedure shows you how to configure the Module Settings for an Ethernet interface
module.
You can determine whether an Ethernet or Fiber module has been detected by looking at the Module
Settings menu.
To configure the Module Settings for an Ethernet interface module:
1. To view status information about Main Stations:
a. In Menu mode [ ], select Networking.
Notes:
The Networking menu only appears if at least one Ethernet or Fiber interface module is
detected.
b. From the second menu (second display option), select Stations. A list of station IDs is
given for each Main Station in the network. Each station ID in the list is preceded by the
letter L- for the Local station itself and R- for all remote stations.
c. From the third menu (third display option) select the required station ID.
d. From the fourth menu (fourth display option) you can view the following:
• Status – Enabled or Disabled
• IP – The IP address.
2. To enable or disable linking:
a. In Menu mode [ ], select Networking.
Note:
The Networking menu only appears if an Ethernet or Fiber interface module is detected.
b. From the second menu (second display option), select Linking.
c. From the third menu (third display option), select Link Station.
d. From the fourth display screen, select one of the following:
• Disabled
• Enabled
Note:
The default is Disabled
63 HelixNet Partyline User Guide