Clear-Com HLI-FBS - Manual (Page 70)

5.7.6 Saving and restoring the software settings.
To save or restore the software settings:
1. In Menu mode [ ], select Administration and then Settings.
2. To save, in the third menu (display screen), select Save. Once you select Save you should not
remove the USB stick right away. Depending on the USB stick it might take up to 5 seconds to
complete.
a. In the fourth menu (fourth display screen), select between saving to a USB or saving
locally.
3. To restore, in the third menu (display screen), select Restore.
a. In the fourth menu (fourth display screen), select between restoring from a USB or
restoring from a list of files.
5.8 Diagnostics
The Diagnostics menus help you to monitor the performance of the Main Station and diagnose possible
system issues.
5.8.1 Viewing hardware information
To view information about the hardware (PCBs) on the Main Station:
1. In Menu mode [ ], select Diagnostics and then Hardware.
2. From the third menu (third display screen), select one of the following:
• Main PCB
• Slot 1 PCB
• Slot 2 PCB
• Slot 3 PCB
Note:
Slot 1, Slot 2 and Slot 3 refer to the interface module slots in the Main Station extension
bay.When looking at the rear of the module,slot 1 is the left-hand slot, slot 2 is the middle slot,
and slot 3 is the right-hand slot.
The fourth menu (fourth display screen) displays the Part, Revision and Serial numbers for the
PCB. The format is similar to the following:
Part xxxxxxZ
Revision: x
Serial: x
Where x is a numerical value.
68 HelixNet Partyline User Guide