Clear-Com HLI-FBS - Manual (Page 68)

5.7.2 Updating the software
Important note:
The following procedure is relevant to future software updates only. Customers will be contacted by
email when software updates become available. Updates will be downloaded through a link provided in
the email.
Any HBP-2X beltpacks that are connected to the Main Station are automatically updated. The beltpacks
remain non-functional for approximately 5 minutes while they are updated. You can also use a USB
memory stick (USB 2.0 Micro-AB) to make the software available to the beltpack.
To update the software:
1. After downloading the software update, copy the update to a USB memory stick.
2. There are two USB connectors available on the front panel:
• USB 2.0 (Micro-AB) connector.
• USB 2.0 (A) connector.
Note: For more information, see
O P
in Table 4: Key to HMS-4X Main Station front panel
diagram.
Insert the memory stick into the appropriate USB connector.
3. In Menu mode [ ], select Administration and then Software.
4. From the third menu (display screen), select Update.
5. The fourth menu (fourth display screen) displays the new software version information on the
USB memory stick. To start updating the Main Station with the new software, press the rotary
control [ ].
The process of updating the software takes several minutes. The following system messages are
displayed during the process:
• Downloading file components
• Erasing Flash
• Copying new files
• Update successful
Do not turn off the power to the Main Station during the software (firmware) update.
Turning off the power can damage the device.
Note:
The Main Station resets automatically. You are not required to restart the Main Station. To check that
the software upgrade was performed successfully, see 5.7.1 Viewing the current versions of the
software.
66 HelixNet Partyline User Guide