Clear-Com HLI-FBS - Manual (Page 61)

8. The VOX Delay OFF setting determines the length of time to wait before deactivating the
incoming audio. To set the VOX Delay OFF setting:
a. From the third menu (third display screen), select VOX Delay OFF.
b. From the fourth menu (fourth display screen), select one of the following:
• [0].5 sec.
• 1 sec.
• 2 sec.
• 3 sec.
• 4 sec
Note:
The default is [0].5 sec.
c. To enable (confirm) the selected setting, press the rotary control [ ].
5.6.2 Configuring a Two-wire interface module
The following procedure shows you how to configure the Module Settings for a Two-wire interface
module.
Note:
The Two-wire interface module must be able to receive power from the Pl line .
To configure the Module Settings for a Two-wire interface module:
1. In Menu mode [ ], select Module Settings.
2. From the second menu (second display screen), select one of the two available ports on the two-
wire interface module:
Slot 1/Port A 2W
Slot 1/Port B 2W
Notes:
In this example, the two-wire module has been fitted to slot 1 in the expansion bay. The
expansion bay contains three slots (room for three interface modules).
2W = Two-wire.
a. To associate one of the four available channels (or to disable channels associations) with
the selected port:
From the third menu (third display screen), select Channel Assign.
59 HelixNet Partyline User Guide