Clear-Com HLI-FBS - Manual (Page 105)

9.4.5 Four-wire connection to CellCom / FreeSpeak
To connect your HelixNet Partyline system with a CellCom / FreeSpeak basestation (Main Station), using
a four-wire connection:
1. On the HMS-4X Main Station, configure the Module Settings for the four-wire interface module.
For the procedure, see 5.6.1 Configuring a Four-wire interface module.
2. Connect the HMS-4X Main Station and the CellCom / FreeSpeak basestation, using four-wire
crossover CAT5 cabling.
Important note:
For pinout information for the two systems, see the quick reference diagram in
9.4.4 Quick reference: Four-wire connection to CellCom / FreeSpeak.
RJ-45 connectors are located:
• On the HMS-4X Main Station four-wire interface module.
• On the back panel (rear) of the CellCom / FreeSpeak basestation.There are four RJ45
connectors for four-wire connections on the basestation.
3. Adjust the In / Out volume levels, using the CellCom / FreeSpeak front panel display.
For more information, see your CellCom / FreeSpeak documentation.
Tip: To optimize audio quality, you may also want to adjust the Audio Settings on the
HMS-4X Main Station. For more information, see 5.2 Configuring the Audio settings.
9.5 Connecting HelixNet Partyline to the DX210
9.5.1 About the DX210
The Clear-Com HME DX210 is a 2 channel wireless intercom system. The basestation (Main Station)
supports up to 15 beltpacks or all-in-one headsets (headsets operating as beltpacks).
The DX210 supports Clear-Com and RTS cabled two-wire intercom systems, and also has four-wire and
auxiliary audio connections.
The DX210 operates in the license-free 2.4GHz band, and has provisions for spectrum-friendly co-
existence with other devices in the same band.
Tip: For more information about the DX210, see your DX210 documentation or visit the wireless intercom
pages on the Clear-Com website: http://www.clearcom.com/product/wireless .
103 HelixNet Partyline User Guide