Clear-Com HLI-FBS - Manual (Page 64)

9. Enabling RMK [Remote Mic Kill] Input allows an external source (such as the main (base)
station of the connected two-wire system to send an RMK signal to the analog beltpacks attached
to the HelixNet main station.
To enable RMK Input:
a. From the third menu (third display screen), select RMK Input.
b. From the fourth menu (fourth display screen), select one of the following:
• Enabled
• Disabled
Note:
The default is Disabled.
c. To enable (confirm) the selected setting, press the rotary control [ ].
10. Enabling RMK [Remote Mic Kill] Ouput allows you to send an RMK signal from the HelixNet
main station to the connected analog beltpacks.
To enable RMK Output:
a. From the third menu (third display screen), select RMK Output.
b. From the fourth menu (fourth display screen), select one of the following:
• Enabled
• Disabled
Note:
The default is Disabled.
c. To enable (confirm) the selected setting, press the rotary control [ ].
11. If you are setting up a continuous audio (program) feed using the two-wire interface module, then
you may want to enable the VOX functionality. To help reduce redundant noise, the VOX
functionality automatically deactivates and activates the continuous audio feed, at an
automatically determined volume threshold.
Note:
If you assign a program and a two-wire interface to the same channel, VOX is automatically
enabled.
To enable or disable VOX:
a. From the third menu (third display screen), select VOX.
b. From the fourth menu (fourth display screen), select one of the following:
• Enabled
• Disabled
Note:
The default is Disabled.
c. To enable (confirm) the selected setting, press the rotary control [ ].
62 HelixNet Partyline User Guide