Extron Electronics ISM 824 - Manual (Page 82)

Operation and Setup, cont’d
ISM 824 Integration Scaling Multiswitcher • Operation and Setup 3-50
View Comm Settings menu
The fourth menu level, View Comm Settings is reached by pressing the Menu
button four times from the default display cycle, or if at a different menu, by
pressing the button repeatedly times until this menu is shown on the LCD screen.
Default
Cycle
Menu
Menu
Menu
Auto
Image
Output Card
Configuration
30 sec. 30 sec.
Next
Remote Port
9600 RS232
NOTE Changes can only be made while in the Edit mode.
To enter the edit settings mode, press and hold the Enter, Preset,View, and Esc
buttons together for 2 seconds. The LCD screen changes from View Comm
settings to Edit Comm Settings.
Menu
View Comm
Settings
Menu
30
sec.
30
sec.
Input
Configuration
Config Port
Next 30
sec.
005A602395B
MAC Address
Next 30
sec.
Off
DHCP Mode
Next
Rotate either encoder to turn DHCP
Mode On or Off.
30
sec.
In edit mode, rotate encoder to select the baud rate.
Rotate encoder to select the connection type (RS-232
or RS 422) for the rear panel 9-pin D-sub control port.
9600 RS232
In edit mode, rotate encoder to select the baud rate.
Rotate encoder to select the connection type (RS-232
only) for the front panel config. port.
NOTE This setting cannot be changed.
192.168.254.254
IP Address
Next
30
sec.
255.255.255.000
Subnet Mask
Next
30
sec.
000.000.000.000
Gateway Address
Next
30
sec.
In edit mode, rotate encoder to select the field
to edit. Rotate encoder to change the field value.
In edit mode, rotate encoder to select the field
to edit. Rotate encoder to change the field value.
In edit mode, rotate encoder to select the field
to edit. Rotate encoder to change the field value.
Next
Menu
System Reset
Menu
Figure 3-50 — View/Edit Comm Settings menu
This menu allows the user to view the following device communication settings:
Remote port, Config port, MAC address (view only), DHCP mode, IP address,
Subnet mask, and Gateway address.
N These settings can only be changed when in the Edit Comm Settings menu. See
“Editing the communications settings” section in this chapter for method.
To simply view the Comm settings, do the following:
1 . From the default cycle, press the Menu button four times to go to the View
Comm Settings menu (see figure 3-50).
2 . Press the Next button to enter the first sublevel, Remote Port (rear panel).
3 . To view the remaining settings, continue to press the Next button and
navigate through each setting.
4 . Press Next in the Gateway Address menu to return to View Comm Settings.
N Press the Menu button to go directly to the next top level (System Reset) menu.